The Atlant electronically controlled washer gives a malfunction code on the display. Whereas on the washing machines with electromechanical control the 2nd and 4th indicators will light up.
What does error F5 mean for Atlant washing machines? Water supply problem. How to fix the situation, consider further.
Finding the cause of the malfunction
If, after starting the program, water does not accumulate, and the machine shows error F5 on the display, there is a possibility of a breakdown in the filling valve. But before disassembling the Atlant washing machine, other options for malfunctions must be excluded.
What do we have to do:
- Check the filter screen between the inlet hose and the Atlant washing machine. A filter clogged with debris will not allow water to pass through normally, so remove the element and remove the blockage.
- Turn the water valve. With incomplete opening, a small pressure is formed, so the valve must be opened at full power.
You tried all the methods, but the F5 error did not reset. How then to fix the malfunction? It is necessary to check the valve itself and its coil on SM Atlant.
Diagnostics and repair
Let's look at the principle of the valve. Usually it is in the closed position, but when voltage is supplied to its coil, the valve opens - water is poured. Depending on the model of the Atlant washing machine, the element is installed on one, two and three coils.
In order to remove the F5 error in the CMA Atlant, as well as to eliminate the breakdown, check the valve operation. What does it mean:
- Remove the top cover of the washer by unscrewing the two screws on the back.
- The element is located on top of the wall.
- Open the water supply (do not forget to substitute the container).
- Apply 220 volts to each coil.
- The service valve will open.
If it didn’t open, check the resistance of the coil. For this:
- Connect the multimeter probes to the coil.
- Measure the resistance.
- The working coil will show 2 to 4 ohms.
You can remove the defective coil and install a new one.
Plastic inserts
Another common problem is the plastic inserts that are located in the fittings to control the pressure of water. If the insert malfunctions or falls out, the pressure will be too high. Error F5 will be displayed on the screen.
In this case, the valve must be completely replaced.
Self replacement
Be consistent:
- Turn off the water supply.
- Use pliers to remove the clamps on the valve hoses.
- Disconnect the hoses (note that there may be water in them).
- Loosen the fastening screws or unfasten the latches.
- Install the new part in the reverse order.
Now start the Atlant washing machine, check its performance. If everything is in order, and the error does not appear again, then everything is done correctly.
Wiring failure
Another reason why the Atlant washing machine generates an F5 error may be a violation of the wiring between the module and the valve. Visually inspect the loop at the time of violations, tighten the connection. With minor damage, the wire section can be insulated. You may need to completely replace the cable.
If you can’t solve the problem and fix the F5 error yourself, call the wizard.